Earlier this year I wrote a blog about ceilings, with quite a detailed discussion on cornices, the detail at the junction of the wall and ceiling. Today I am setting my sights (literally) much lower in the room to look at the junction between floor and wall.  |
| A moulded wooden skirting and quadrant |
Skirtings probably had their origin with the use of wooden plank flooring that was fixed to wooden joists that created an airspace below the flooring. The timber planks needed to be able to expand during warm or damp weather, and contract again in cool weather or when the air dried out. This meant that there needed to be a gap between the flooring and the walls, usually quite mall - 2mm to 5mm - but enough to leave a visible gap that would allow floor dirt to accumulate and for bugs living in the airspace below to come up into the room. A strip of wood fixed to the wall would be the first step in closing this gap, while still allowing the floorboards to move, but often these would be supplemented with a quadrant bead, a strip of wood in the shape of a quarter circle.
 |
| A detail showing the quadrant bead |
Not only did this combination of skirting and quadrant close the gap between wall and floor boards, but it also protected the bottom of the wall from floor polish smears and damage from floor cleaning. The quadrant, in particular, is normally fixed to the skirting with widely-spaced panel pins - easily removed and replaced if they become excessively damaged or if one needs to use a large floor-sander that cannot reach right into the junction with the wall.
With the advent of concrete floors with cement screeds, the original purpose of the skirting fell away, allowing a crisp junction much favoured by Modern Movement architect in the first half of the 20th Century. I am quite sure that this aesthetic was not nearly so popular with the building contractors who had to turn the crisp drawings into a neat reality!
Floor finishes commonly used on concrete floors, such as ceramic, stone or vinyl tiles can be far more efficiently laid if they do not need to be cut to millimetre accuracy. The entire flooring process can be streamlined if the tiler knows that the carpenter will be coming in to do the final detailing.
But we often see a tile skirting in bathrooms and kitchens, rooms that are not friendly to wood trims because of the amount of moisture from bathing and floor cleaning. This is best done by laying the floor tiles and then doing the tiled skirting or even the whole wall. In this sequence, the wall tile can cover any irregularities in the floor, with the skirting often being the depth of a whole tile to avoid the need for cutting..jpeg) |
| A natural stone tile skirting in a bathroom |
The other very common floor finish in contemporary houses that benefit from the skirting and quadrant combination are wall-to-wall carpeting. Not only is it difficult to measure and cut a long strip of carpet to millimetre accuracy, but the edges often fray easily, needing some form of edging. At doorways and sometimes next to cupboards, a flat metal cover strip (originally brass, but now more often aluminium) are needed, as a timber cover would be too chunky and a potential tripping hazard.  |
| An aluminium cover strip at the edge of a carpet next to a cupboard. |
In most standard specification homes, skirtings have become pared down to the minimum to save costs, Typically a skirting will only be 75mm high, whereas in older or more luxurious homes, they could be twice as high. Also for reasons of cost-cutting, most skirtings these days are simply rectangular, with a slightly rounded edge to prevent splintering, while older or higher-spec houses may have quite elaborately moulded ones. |
| A moulded skirting carefully mitred at the staircase |
Skirtings are one of those small details that we are often not conscious of, but subconsciously they contribute to the overall aesthetic of a space, whether stripped and minimalist, or rich and luxurious.
Comments
Post a Comment